Small Servo Electric CNC Bending Machine: Built For Small Parts
Most press brake literature is written for the 3,200 mm, 200-tonne machine in the corner. But a large share of the world's bent parts are small: brackets, terminal covers, chassis clips, filter housings, hinge plates, contact springs, mounting ears. They are 0.5 to 2 mm thick, 50 to 400 mm long, and produced in batches of 200 to 5,000.
Bending those on a big hydraulic machine is like using a lorry to deliver letters. It works, it is slow, and the operator spends more time handling the machine than the part. A small servo electric CNC bending machine is built around the opposite assumption.
The Drive Difference
No oil, no valve, no warm-up
A servo electric press brake drives the ram through servo motors and ball screws. There is no hydraulic power pack, no proportional valve, no oil tank. That single change removes a surprising amount of operational friction:
• No warm-up. A hydraulic machine needs its oil at working temperature before the first part is in tolerance. An electric machine is ready when the control boots.
• No oil temperature drift. Viscosity-driven angle drift through the afternoon simply does not exist.
• No oil leaks on the floor. In electronics assembly, medical device or cleanroom-adjacent work, that is...
2026-11-16